Double light switches are a common feature of the Australian home, allowing you to control two lights from one switch. Wiring them up can be a bit tricky, but with some patience and the right tools, it’s a job anyone can do. In this blog post, we’ll walk you through the steps of wiring a double light switch in Australia.
To get started, you’ll need to gather your supplies. You’ll need a double light switch, a screwdriver, electrical tape, and wire cutters. You should also have a circuit tester handy to check that the wiring is correct before you turn the power back on. Once you have all your supplies ready, you can begin.
First, you’ll need to turn off the power at the mains. This is an important safety precaution, so make sure the power is off before you start. Next, you’ll need to remove the existing switch and disconnect the wiring. Then, you’ll need to connect the two wires for the new switch according to the manufacturer’s instructions. Make sure to wrap the connections in electrical tape for added safety. Once the wiring is connected, you can install the new switch in the same way as the old one was installed.
Finally, it’s time to turn the power back on and test the switch. Make sure it is functioning correctly and that both lights turn on and off when the switch is flipped. If it’s working properly, then you’re all done! Wiring a double light switch in Australia doesn’t have to be a daunting task. With the right supplies and a little patience, anyone can do it.
